2019/07/22

2019_07_22 Diddling about....

2019_07_22  Two days in a row tried to complete wiring of helix..distractions?



Well I bought this and it wasn't cheap. It is a very heavy 4 wheel wagon with both axles suspended on a phosphor bronze spring, which allowed it to rock front to back.
So much so that KD's simply uncoupled, and made it difficult to tow or even push around.

So I decided to fix it!





Too cold to go and get better pictures :(  But here you see the wagon sitting low on left side. Push it down on right side and it will also stay down. Not a really suitable vehicle for my purpose.


It is all glued together and is brittle, and I had to drill out the axle keeper to remove the wheels. I did it wong. I should have glued the coupling bars in first, making sure the vehicle sat flat on its 4 wheels and the coupling bars were horizontal. Once the bars were dried, I glued styrene extensions to the coupling bar long enough to fit KD's to ends and sit on two SEM trucks which supported the device exactly as high as the original two axles did, thus applying correct pressure on the sanding disk, or the polishing disk fitted to the vehicle.  I did it the hard way, but eventually got there.


Used gorilla glue as it sets hard and expands to fill all gaps. I just need to cut away excess and lightly sand before painting. Notice the coupling on left dropped. Easy enough to fix.


I used U section styrene which was two light and allowed body to sag. So I filled the U section with Gorilla glue which stiffened it up. It does not bend now.

 .
 Just needs filing and cleaning up of the U beams where gorilla glue expanded. the wagon is now stable and exerts a solid pressure on rail. Might have to remove a weight or two, as a 442 had trouble pushing it. This is the third vehicle in my maintenance train.

I have a Roco/Atlas powered Track cleaner that power vacuums the track, washes it with solvent or polishes the rail packed away.. and as well.....



This DCC controlled scrubber fitted with spinning polishing wheels. The wheels spin in opposite directions which powers it along slowly, and it does a good job.

Cheers
Rod

No comments:

Post a Comment

All comments and suggestions from like minded individuals always welcomed. Help make this railway better :D